VLL1582609, 221307 #01B3CC

Old Part Numbers: S145-0543, 145-0456Stainless steel braided tube that runs from pump to tank. Replace if leaking.  Specifications5.5" long with 3/8" compression fittings on each end

Old Part Numbers: 031-00723/8" compression inlet x 1/2" male NPT outlet check valve with 1/8" hole and plug. If the small unloader (bleeder) valve on or under your pressure switch leaks constantly AFTER the unit shuts off, replace this part. The check...

Isolator Pad (foot). Two are required.

Belt - .650" Wide, (5/8") 6" Diameter. Is your motor turning yet you have no pressure? Typically this is caused by a torn belt. To make installation easier, "walk" the belt onto the pulleys like you would a bicycle chain.

(incl. 5,6,7) Valve plate and gaskets. Poor performance or air leaks out of the intake filter while the unit is running? This is probably the problem.

(ea.) O-ring 3 req'd.

Hubcap for wheel, 1/2". Two required.

Old Part Numbers: 093-0050Rubber grommet for pump/motor assembly. Keeps your motor stable and reduces vibration.

Head o-ring gasket.