OLF-3500 Air Compressor Pump / Motor Replacement, Complete Assembly, 220V / 3-PHASE, Ultra Quiet, Oil-Free, 6.5 HP #11670A

Complete OLF-3500 replacement air compressor motor / pump assembly for the CAT-60065C air compressor.

The Powerful OLF-3500 6.5 HP motor/pump operates at only 1,680 RPM creating less noise and less wear. The Oil-Free OLF motor/pump is engineered for high performance and durability. The Oil-Free pump allows for use in a variety of temperatures (cold starts; no oil in the pump).

• Low Vibration
• Less Heat – Dissipates heat more efficiently
• Thermal Overload Protector
• ETL Certified

• HP: 6.5 HP
• Stages: Single-Stage
• Drive: Oil-Free / Direct-Drive Quad-Cylinder (cleaner air for better tool operation)
• dB Rating: Ultra quiet, only 85 dB
• Amps: 15.0 (no capacitor)
• Voltage: 220V / 60Hz / 3-PHASE (200-250vac operating volt range)
• CFM Delivery: 20.0 CFM @ 40 PSI / 17.0 CFM @ 90 PSI
• Maximum Output Air Pressure: 480 l/min @ 90 PSI*
• Max PSI: 145 PSI
• Weight: 58 lbs.
• Dimensions (LxWxH): 11.5" x 6.5" x 6.4"
• Warranty: 1 year limited

*Regulated Output Pressure may not be adjusted any higher than the default output pressure level of 90 PSI.

Installation Requirement: Unloader and/or Bleeder Valve Required

Comes complete with:

• (4) 2.0 Hp Air Filters
• (4) 4″ Air Intake Tubes
• (4) Shock Struts

OLF-3500 Periodic Maintenance:

A. Service/replace piston seals every 2,000 operating hours (see photo below). Replacement Piston Seal 4-Pack – Part Number 91457-4P.

B. Replace air filters every 2 years or every year if compressor is exposed to a dirty or dusty environment. Four air filters are attached to motor-pump. Part Number 90260.

NOTE: This is NOT an air compressor. This is a replacement motor-pump which can be installed into existing California Air Tools equipment or third party compressor models (location holes may need to be adjusted on select models).

CAUTION: If installing onto a non-California Air Tools air compressor or unique application you will need to have the electrical and mechanical knowledge for properly installing this motor-pump. It is important to properly configure an UNLOADER valve and CHECK VALVE with the motor pump (to correctly bleed pressure off of the pistons) otherwise damage to motor may occur.