Air Compressor Piston / Cylinder Kit #059388

(1 review) Write a Review
Calculated at Checkout
On Sale
Now: $55.95
Was: $68.06


Old Part Numbers: 048-0131, E101275, E103495, E103862, E100290, E100292, E100294, E100293

Includes connecting rod / piston assembly, piston ring, spacer, conrod screw, nut, piston cap, screw, and cylinder.  

Replacing the cylinder sleeve and piston ring usually restores compression in oil-free units. Inspect the reed valves as well, but unless the valves are obviously broken or cracked the problem is the compression ring and cylinder, and replacing this kit should make the compressor run like new again.

Extra Details

Important: Use the correct spacer gasket that are provided in the kit.

The spacers (gaskets) are used to control the proper clearance between the con-rod cap and the valve plate in the pump assembly. If your original pump had the spacer(s) in place then you will need to use the same color spacer from this service kit. Each kit comes with two spacers, one is green in color (approx. .013” thick) and the other one is gray in color (approx. .039” thick).

The spacers (when used) are intended to be placed between the pump casting and the cylinder sleeve (see below image). If the incorrect spacer is used or if you place them on top of the cylinder sleeve instead of under it, the con-rod cap could hit the valve plate assembly. It's always recommended to rotate the pump by hand after re-assembly (prior to plugging it in) to ensure that there is no binding (proper con-rod centering in the sleeve) or contact with the valve plate!


View AllClose

1 Review

  • 5
    Piston Kit #059388

    Posted by Rick vanAdrichem on Jan 24, 2023

    Fit perfectly, and easy to install.

View AllClose