Old Part Numbers: KK-4930, KK-4949Order this kit if replacing the N017592SV Valve Plate Assembly. Used on many Craftsman, DeVilbiss, DeWalt, and other units. If the compressor pump doesn't seem to...

Old Part Numbers: Z-A08548, Z-D29777Valve Plate Assembly, includes Valves and Cylinder Gasket (Head Gasket sold separately). Genuine Porter Cable replacement part. Broken valve causing slow pump up...

Replace this Tube Seal when replacing the Piston/Cylinder Kit, and if air is leaking from the head at the outlet.

Old Part Numbers: KK-4964Includes piston / rod assembly with piston ring, cylinder, and rod bearing.  If you have a sudden loss of performance, replacing the cylinder sleeve and piston ring usually...

Old Part Numbers: SRV250175, 1229O-175Air compressor safety relief valve, 1/4" MPT, 175 PSI, ASME. If your valve leaks below the pressure listed on the side of the valve, replace this vital safety...

Hose Clamp for the Discharge (Outlet) Tube/Hose.

Old Part Numbers: CAC-1199Replace this when replacing the piston/cylinder. Since the gasket is graphite, it cannot be reused if the head is removed. NOTE: Used with NEW-style valve plate.

Dayco Timing Belt. Replace if slipping or frayed.

Air compressor regulator repair kit includes the plug with ring, o-ring, spring, piston with seal, disk with o-rings, and seal lube with instructions. Used on many brands from Craftsman to DeVilbiss...

Old Part Numbers: D20763, D27254, D206434-Port OEM Air Regulator. The Regulator controls the amount of air to your hose. Replace this if you're not able to adjust the PSI to your hose or if it leaks...

1/4" male NPT x 1/8" female NPT brass bushing reducer for air compressors.

Rubber Foot. Click Here to find a replacement rubber foot.

Bare pump Head (no gaskets or seals included). Torque head bolts down to 52 in/lbs.

Screw for the pump head. NOTE: Torque head bolts down to 52 in/lbs.

Old Part Numbers: D29132 Also available in Fastener Kit # KK-4929.

Old Part Numbers: SSW-7367Strain relief for air compressor power cord going into the pressure switch housing.

Screw that fastens the front and back of the belt  guard to each other, and to the compressor base. THD FORMING

Screw for the piston rod cover.

Old Part Numbers: CAC-1213Isolator for the pump. Keeps the pump from vibrating against the plastic shroud.

Old Part Numbers: D24888, D30198, 5135135-00Pipe Nipple, 1/4" male NPT x 1/4" long. Don't forget to apply Teflon Tape to the threads to seal it.

Old Part Numbers: SSF-3147Part of piston/connecting rod kit.

Old Part Numbers: A14877, N044990, SS-1286, 5130029-00, 5131153-001/4"-18 x 1" male NPT close pipe nipple. For model D55167 type 1 & 2 and others. Remember to apply plumber's tape to the threads.

Old Part Numbers: SSF-993 Also available in Fastener Kit # KK-4929.