Old Part Numbers: Z-AC-0032, AC-0032Valve plate comes with preinstalled valves and o-rings. Poor performance or air leaks out of the intake filter while the unit is running? This is probably the...

Old Part Numbers: K0058, K-0058, K0650, K-0650 Sears 919.16014, 91604, K-0650Compression ring replacement kit includes the cylinder, piston ring, retaining screw, o-ring, and head o-ring. Restores...

Plastic fan to cool pump and motor. 6" outside diameter.Specifications Length: 5" Width: 5" Height: 1.850"

Air compressor check valve. 3/8" Comp x 1/2" MPT with 1/8" FPT side port.  The check valve is a one-way valve that prevents air from back-feeding from the air tank. If your unit has a hard time...

O-ring Seal for the discharge (outlet) tube to the pump head.

Head Gasket

O-ring seal for air compressor valve plate, installs in between the cylinder and valve plate. Used with origina

Old Part Numbers: 5130038-00, 5130024-001/4" OD brass compression nut and sleeve for bleeder (unloader) tube for air compressors.

Order this if ordering valve plate or a new head.

Brass compression nut and sleeve for 3/8" OD tubes.

Rubber o-ring for air compressors, .362ID x .103W. This is the o-ring seal for the pump end of the outlet tube.

Screw (fastener) for the motor/pump shroud.

Isolator for the pump/motor assembly base. NOTE: To replace all of them you will need to order a quantity of 3. Keep your compressor from vibration damage and replace if any are missing.

Hex Nut for the pump head. The discharge tube attaches to this part. Order the required AC-0781 O-ring Seal as well if needed.

Old Part Numbers: AB-ACG18Saddle mount cup for the motor/pump feet. This installs on the mounting feet of the motor/pump assembly and keeps it from vibrating, as well as reducing noise.

1/4" male NPT x 1/8" female NPT brass bushing reducer for air compressors.

Old Part Numbers: D20675, AC80-BQuick-connect coupler, 1/4" male NPT x 1/4" body.

Old Part Numbers: 5130940-00, SSF-8080-ZNFlange nut to attach the wheel to the air tank.

Screw, .250-20 x 1.25" U. This is one of the screws for the pump head; also used to attach the saddle mount cup/foot to the base of the pump.

Old Part Numbers: SST-108, A14785Rubber air compressor isolators with screws, three (3) included.

Old Part Numbers: SSF-3158-1This is the screw that holds down the piston cover, on the top of the piston.

Screw for the eccentric bearing assembly on crankshaft.

Screw, #10-14 x 2.50". This is the screw for the air intake muffler cover (2 used).