Keep your air compressor from sliding all around your vehicle or floor. Order extra for future use.Specifications Height: 3/4"  Diameter: 1-1/2"

Old Part Numbers: 5130038-00, 5130024-001/4" OD brass compression nut and sleeve for bleeder (unloader) tube for air compressors.

1/4" NPT wingnut drain cock. Prevent rust from ruining your air compressor tank by draining your tank daily. Keep an extra around for a spare.Extra DetailsThis was a new check valve installed less...

Brass compression nut and sleeve for 3/8" OD tubes.

Isolator for the pump/motor assembly base. NOTE: To replace all of them you will need to order a quantity of 3. Keep your compressor from vibration damage and replace if any are missing.

Old Part Numbers: AB-ACG18Saddle mount cup for the motor/pump feet. This installs on the mounting feet of the motor/pump assembly and keeps it from vibrating, as well as reducing noise.

Old Part Numbers: 69D109668Pressure switch cover for most 69 Series Furnas/Hubbell air compressor pressure switches.Specifications 3-3/8" long x 2-3/16" wide x 1-1/2" tall

1/4" male NPT x 1/8" female NPT brass bushing reducer for air compressors.

Old Part Numbers: 68-4-21/8" male NPT x 1/4" compression adapter for air compressor unloader/bleeder line. A very common adapter to attach the 1/4" OD unloader/bleeder line from the unloader valve on...

Old Part Numbers: SSW-7367Strain relief for air compressor power cord going into the pressure switch housing.

Screw that fastens the front and back of the belt  guard to each other, and to the compressor base. THD FORMING

Plastic shroud (cover) Screw, #10-9 x .500 Thd. 

Old Part Numbers: SSF-993 Also available in Fastener Kit # KK-4929.