Old Part Numbers: Z-AC-0032, AC-0032Valve plate comes with preinstalled valves and o-rings. Poor performance or air leaks out of the intake filter while the unit is running? This is probably the...

Old Part Numbers: K0058, K-0058, K0650, K-0650 Sears 919.16014, 91604, K-0650Compression ring replacement kit includes the cylinder, piston ring, retaining screw, o-ring, and head o-ring. Restores...

Plastic fan to cool pump and motor. 6" outside diameter.Specifications Length: 5" Width: 5" Height: 1.850"

O-ring Seal for the discharge (outlet) tube to the pump head.

Old Part Numbers: NTB14Use this nylon tube if your air compressor pressure switch has a plastic unloader valve with a quick-connect fitting. Note: sold by the foot (quantity of 1 = 1 foot or 12...

Old Part Numbers: AC-0037, ACG-26Pump head 3/8" FPT filter port and 3/8" outlet portSpecificationsThis head has 3/8" FPT threaded ports on both sides. If your head has a 3/8" port 90° from the air...

O-ring seal for air compressor valve plate, installs in between the cylinder and valve plate. Used with origina

Old Part Numbers: 5130038-00, 5130024-001/4" OD brass compression nut and sleeve for bleeder (unloader) tube for air compressors.

Must order quantity of 4 for complete set. 1/4"-20 x 1-1/4 length.

Order this if ordering valve plate or a new head.

Screw for the plastic motor/pump shroud.

Brass compression nut and sleeve for 3/8" OD tubes.

Air compressor compression ring, pre-formed. Note: After you install the ring on the piston rod, install the rod in the cylinder by inserting the rod from the top of the cylinder and pull it down...

Isolator for the pump/motor assembly base. NOTE: To replace all of them you will need to order a quantity of 3. Keep your compressor from vibration damage and replace if any are missing.

Hex Nut for the pump head. The discharge tube attaches to this part. Order the required AC-0781 O-ring Seal as well if needed.

Old Part Numbers: AB-ACG18Saddle mount cup for the motor/pump feet. This installs on the mounting feet of the motor/pump assembly and keeps it from vibrating, as well as reducing noise.

Old Part Numbers: SRV187150, SRV187-1/8Air compressor safety valve, 150 PSI, 1/8" male NPT. If your valve leaks below the pressure listed on the side of the valve, replace this vital safety feature.

Old Part Numbers: 68-4-21/8" male NPT x 1/4" compression adapter for air compressor unloader/bleeder line. A very common adapter to attach the 1/4" OD unloader/bleeder line from the unloader valve on...

Old Part Numbers: SSW-7367Strain relief for air compressor power cord going into the pressure switch housing.

Old Part Numbers: SSF-3158-1This is the screw that holds down the piston cover, on the top of the piston.

Screw, #10-14 x 2.50". This is the screw for the air intake muffler cover (2 used).