Old Part Numbers: 019-0246, 019-0023Replacement air filter element, Rolair 431. Fits the K12 through K30 air compressor pumps.

Old Part Numbers: 61-8

Old Part Numbers: CW207594AVThe Condor 11QCXF OEM pressure switch replacement is an MDR11 style, 4-port, 1/4" female NPT pressure switch with manual on/off switch and 90-degree quick-connect style...

Old Part Numbers: SV25200, SRV250200, 1229O-200, 9710533300, 136-0007RPAir compressor safety relief valve, 1/4" MPT, 200 PSI. If your valve leaks below the pressure listed on the side of the valve,...

Old Part Numbers: CV221502AJ, CV221502SJ, CTD1212QR1/2" Compression x 1/2" MPT air compressor check valve with quick-release fitting for unloader/bleeder tube. The check valve is a one-way valve that...

Old Part Numbers: 60-8, STD-329Air compressor brass compression sleeve (ferrule) for a 1/2" OD tube.

Complete air compressor gasket kit for high-pressure and low-pressure side, includes head gasket, valve plate gasket, cylinder gasket, crankcase gasket, bearing cover gasket, oil seal, and o-ring.

3/8" male NPT Drain Cock for the tank. Prevent rust from ruining your tank by draining your tank daily. Keep an extra around for a spare!

Old Part Numbers: GA031900AVAir compressor pressure gauge. Replace if cracked or reading inaccurately. Specifications 1/4" MPT 2" Face Right-Mount 300 PSI

Old Part Numbers: ST119301AV, QR1/8" NPT x 1/4" nylon tube. This allows 1/4" nylon tubing to push to fit into this fitting. The 1/8" MPT threads screw into the unloader area of the air compressor...

Old Part Numbers: HS015200AP

Old Part Numbers: BT009701AV64" v-belt for Husky Stationary Air Compressor DP561000, EX840200, DP581100, DP581200, DP581900, and other air compressors.Specifications Type: "A"-groove v-belt Width:...

Old Part Numbers: HS7101, HS5010Complete HS7101 v-twin, two-stage air compressor replacement pump with flywheel, 5 HP. This pump replaces the HS050000AV pump. Ready to run. Just bolt on, add oil,...

HP Air Compressor Pump Valve Plate Kit (with valves), including the head and cylinder gaskets. If air leaks out of the intake filter or if the compressor just isn't performing like it should, order...

Complete Valve Plate Assembly for the larger, Low Pressure (LP) cylinder. Includes gaskets and reed valves. If air leaks out of the intake filter or if the compressor just isn't performing like it...

Old Part Numbers: ST070387AV-MAT1/4"-18 NPT x 2.5" long pipe nipple for air compressors. Don't forget to apply plumbers' (teflon) tape to the threads for a tight seal.Extra DetailsIf you have a...

Includes all piston rings (High & Low pressure) for the pump.

NOTE! This flywheel will only fit units made AFTER March 2008. Flywheel for units made previous to this date is no longer available. OD: 16.5" Tapered Shaft: Large, (inside) 1.34" Small, (outside) 1...

Old Part Numbers: ST117804AV, ST117802AV1/4" OD Unloader/Bleeder Tube, 19" length. This is the tube that routes from the pressure unloader valve to the in-tank check valve, which unloads the head...

Conrod assembly for the low pressure (LP) side. Includes dipper. NOTE! This is the NEW-style rod and will only fit pumps made after 2008! The old conrod is no longer available. The new rod is nearly...

Air compressor piston ring set for the smaller, HP piston. Includes comp ring and oil ring. Stagger ring gaps and hone the cylinders when installing. Also available in the HS050000AVRINGS kit. It's...

Old Part Numbers: ST016500AV

Air compressor duty 1205T-ODP electric motor. 5 HP, 208-230V, 3,600 RPM, 7/8" Shaft, 143/5T Frame. The 1205T-ODP is a popular 5 HP motor for home and shop air compressors.Specifications Model:...

Old Part Numbers: 68-8-81/2" compression x 1/2" male NPT compression connector/fitting for air compressors.

Air compressor pump ring set for Low Pressure (LP) piston only. Order HS050000AVRINGS kit if you need a complete ring set. Don't forget to order new gaskets. Stagger ring gaps a

Includes wrist pin and clips.

Low pressure cylinder head for the Campbell Hausfeld HS050000AV pump.  Sale item - 1 in stock (no returns).

Includes flare nuts.

Oil Sight Gauge (Glass) with O-ring.

Includes gaskets.

Includes baffle.

Includes crankcase assembly with seal, gauge, drain & fill plugs.

Kit includes # 6-8.

High pressure cylinder head for the Campbell Hausfeld HS050000AV pump.

Includes wrist pin and clips.