Replacement paper filter element for twist-lock air filter assembly for air compressors. Element only. Replacing the pump's air filter regularly is important to maintain the performance and longevity...

Old Part Numbers: FS-10-052Twist-lock air filter assembly for air compressors. 1/2" MPT. Includes 10-SOL filter element. Replacing the pump's air filter regularly is important to maintain the...

Old Part Numbers: L54EReplacement air filter element. 3-3/4" OD x 1-1/4" ID x 2-5/8" High. For A Series units and for filter assemblies with separate cover and wing nut (L54E). Includes the element...

Old Part Numbers: L21K, 310-1001-01Replace this if worn or damaged. Torque to 120 in lbs. (Includes bearing shell inserts). NOTE: These new-style rods will install on old-style (non-bearing insert)...

Old Part Numbers: L140Emglo/Jenny complete air compressor valve plate assembly. Includes the valve plate, pre-installed intake and exhaust disc valves, and the upper and lower valve plate gaskets. If...

Old Part Numbers: ESQ, 105-1150Synthetic Blue Air Compressor Oil, 1 Quart. Add oil before use.

Old Part Numbers: K146

Old Part Numbers: K9Bearing for crankshaft. Order one for each side.

Old Part Numbers: 104-1007Valve plate gasket for air compressors. Also available in the KUVALVEKIT, Gasket Kit, or

Old Part Numbers: L53BRACKET,FILTER

Old Part Numbers: K36AWrist Pin Retainer (Bumper).

Old Part Numbers: 610-1026Complete gasket kit for your "K" model air compressor pump. Includes head gasket, valve plate-to-cylinder gasket, crankcase gasket, and bearing cover gaskets. If the...

Complete K model replacement pump assembly with single-groove flywheel and air filter assembly. Usually for stop/start applications. Same as the KU pump except the Jenny K pump does not have head...

Old Part Numbers: 104-1008Head Gasket for air compressors. Also available in the KUVALVEKIT, Gasket Kit, or

Old Part Numbers: 69JF7LY, 5131501-00, PCVLAir compressor pressure switch, 2-3 HP, 100/125 PSI cut-on/cut-off pressure. Has unloader valve and on/off switch. Single-port manifold. Furnas/Hubbell...

Old Part Numbers: K145

Old Part Numbers: K133This air compressor pump ring kit includes rings for two pistons. Order two sets for v-twin air compressor pumps. Stagger rings and hone cylinders.  Replace if the pump is...

Old Part Numbers: K101K Pump rebuild kit includes all gaskets, valves, rings, seals, and air filter element (L54E hollow-style). Everything you need to rebuild your air compressor pump (for...

Old Part Numbers: K132Piston Assy w/ piston, ring set, bumpers and wrist pin. Replace this if the rings do not rotate freely in their grooves.

Old Part Numbers: K11EAir compressor oil seal. Oil leaking around the shaft? Remove flywheel and replace this seal. Need oil? 

Replacement bearing shells for connecting rod. (order 2 for each connecting rod) Works with old style (non-bearing) and new style.

Old Part Numbers: KU181

New-style Jenny "K" replacement pump assembly with single-groove flywheel and air filter assembly. Usually for stop/start applications. Same as the "KU" pump, except this pump is for serial numbers...

Old Part Numbers: KU101GIncludes rings, valves, gaskets, unloader valves, crankcase breather, and air filter element (G54E hockey puck-style filter). If you have a sudden loss of performance, if air...

Old Part Numbers: 68-4-21/8" male NPT x 1/4" compression adapter for air compressor unloader/bleeder line. A very common adapter to attach the 1/4" OD unloader/bleeder line from the unloader valve on...

1/2" FPT x 3/4" MPT air compressor check valve with 1/8" FPT side port. If the small unloader (bleeder) valve on or under your switch leaks constantly AFTER the unit shuts off, replace this part. The...

Old Part Numbers: 220-1032, EQ23, GT23A13.25" OD, 7/8" ID, 2-groove flywheel for model "DC" pump, includes K25 roll pin.

Complete KU replacement pump assembly with single-groove flywheel. Usually for constant spinning applications. The Jenny KU pump has head unloaders but can be used for both start/stop and constant...

Old Part Numbers: K32 Piston and bumpers (no rings).

Old Part Numbers: G54EPPackage of four (4) G54E hockey puck-style filter elements. Element only for air compressor air filter assembly. Replacing the pump's air filter regularly is important to...

Includes intake and exhaust valves and necessary gaskets. Torque to 225 in/lbs. If your unit is using oil, or is not performing like it once did, then you may possibly need to replace the valves...

Old Part Numbers: K101GK air compressor pump rebuild kit includes all piston rings, intake and exhaust valves, gaskets, and air filter elements (G54E hockey-puck style). Note 1: Kit does not include...

Air compressor pump with flywheel and air filter assembly. This pump has head unloaders and is typically used for gas-powered constant-run applications. Single-groove, 10.375" diameter flywheel...

Includes intake and exhaust valves and necessary gaskets. Torque to 225 in/lbs. If your air compressor unit is using oil or is not performing like it once did, then you may need to replace the valves...

Old Part Numbers: 320-1177, 320-1044, BGKDPlease Note: New Style Belt Guard. If Your Serial Number Begins With Letters A-F you will need to purchase quantity  2 of each 5/16”x1” hex stock and 5/16”x...

Old Part Numbers: K25For flywheel. Replace when rebuilding pump. Included in the KU Rebuild Kit.

Old Part Numbers: 154-4L470Air comporessor v-belt, 1/2" wide. Replace if worn or frayed.Specifications Outside dimension: 43" "A" Belt Conversion: A41

Old Part Numbers: L54EThis handy maintenance kit includes one air compressor air filter element and one (1) quart of high-quality full synthetic lubricant to keep your air compressor running like a...

Old Part Numbers: KU101 Kit includes: Rings, Gaskets, Valves, Unloaders and hollow-style Air Filter Element (L54E hollow-style Filter). Note: Kit does not include K11E or K9.

Old Part Numbers: K35Wrist Pin (Piston Pin) for conrod.

Old Part Numbers: L154Newer wingnut-style filter assy with L54E hollow-style element. Uses filter 150-1010-JE filter element. Replacing the pump's air filter regularly is important to maintain the...

Valve Kit for the K Breaker Pump, KW270 and KHVB breaker pumps. Includes stainless steel valves and gaskets. Torque to 225 in/lbs.

Old Part Numbers: MC-5SNote: order this item for model GT5B-120.

Old Part Numbers: 220-1010, K20A

Old Part Numbers: L50Head for K pump (without unloaders).

Old Part Numbers: LU180Head Assy for K, G & W pump.

Old Part Numbers: ESG1 Gallon of premium Jenny Ultimate Blue Synthetic Air Compressor Pump Oil. Formulated specifically for air compressor pumps. ISO 100. This synthetic compressor oil is 20-weight...

Old Part Numbers: K52-1

Old Part Numbers: K30Cylinder for K series and D/DC/DCU air compressor pumps.

Pulley for 1.5 HP units with "B" serial numbers. 5" Diameter, 5/8" Shaft

Old Part Numbers: 220-1093Flywheel, 10 3/8 inch. If yours is bent or cracked, replace it with this one. Save the rollpin.

Old Part Numbers: G154PIncludes four G154 complete filter assemblies. This air compressor air filter assembly is the older twist-lock filter with hockey-puck filter elements. Replacing the pump's air...

Jenny blue paint for Jenny brand air compressors. 12oz spray can.

Old Part Numbers: L55Wingnut for old style air filter.

SCREW,CAP,HEX HD,GR5,ST,BLK

2 FT

1.5 HP, 230-460 Volts, 50-60 Hz/3-Phase, 1,725 RPM.

Old Part Numbers: 122-1042-JE Jenny Pipe Nipple (122-1144)

Old Part Numbers: GV12 Quick and easy 1/4 turn cuts it on or off. Industrial Quality. 1/2" FPT on each end.

Old Part Numbers: L54EThis handy maintenance kit includes one air compressor air filter element and one (1) quart of high-quality synthetic blend lubricant to keep your air compressor running like a...

Old Part Numbers: K14Crankcase bolt (oil fill), K series

LOCK,FLANGE,HEX,SERR,ST,PLTD,5/16-18

1.5 HP, 200-208 Volts, 60 Hz/3-Phase, 1,725 RPM.

New-style Jenny "K" replacement pump assembly with single-groove flywheel and air filter assembly. This pump is used on electric units that use a pressure switch without an unloader valve. This pump...

Old Part Numbers: K15O-ring for oil fill bolt

Old Part Numbers: KU85