NOTE! This Filter will only fit 2HP models! Order part number 90227 for 1HP models. Click here for SKU 90227.Extra DetailsA clean air filter is essential to the performance of an air compress

If your unit has a hard time restarting when trying to cycle, order this. If your pressure switch is leaking out of the small bleeder valve on the side (or located underneath), order this valve...

1/4" Ball Valve Drain Cock for air compressors. Keep your tank from rusting. Replace this if it is leaking or will not work.

Also known as a "cold start" valve, this integral component releases air off of the piston and pump head after it shuts off, which allows the motor to start much more easily and efficiently. This...

Old Part Numbers: 90393Air compressor pressure switch assembly. If the compressor doesn't cut in or cut out at the designated PSI, most likely the pressure switch is defective. NOTE: If your pressure...

2 HP Piston ring for air compressors. This tends to be a high wear part, especially if you are in a high particulate environment. Order the cylinder sleeve when buying this part as the two wear...

California Air Tools Cylinder O-Ring gasket. Note: For newer models with motor serial# ending in "-O".

California Air Tools air compressor exhaust hose for 2HP models. Stainless steel braded fluid hose, 3/8" ID.

"T" fitting for the cold start valve. This valve installs into the pump head. The braided discharge tube threads into one end and the cold start valve is installed in the other.

1/4" Quick Connect for California Air Tools air compressors.

California Air Tools cushion foot

This is the fitting for the small M10 X 6mm uploading tube that routes to the on/off pressure switch.

Gassing Exhaust Valve for air compressors. If you have a loss of compression, replace this exhaust valve and the intake valve.

California Air Tools MP2012-O cylinder for air compressor repairs.  Replace the cylinder if it is damaged or worn, or if you are also replacing the compression ring. NOTE: For newer models with motor...

OEM replacement Pressure Gauge 2.0″ Face, 1/4" NPT Center Back-Mount, 0-180 PSI.

Pressure Gauge for California Air Tools compressors. Replace if the gauge needle doesn't move or if leaking. Specifications 1.5" face back-mount gauge 175 PSI-rated

This is the nylon hose in the intake port of the air intake filter.

Bare Pump Head. Both cylinders use the same pump head. NOTE: Does not include any gaskets/seals, order separately.

2HP Shock Strut

Protect your fingers by keeping the spinning fan covered with this fan cover.