How-To Clean A Motor Starter Switch
Cleaning a Motor Starter Switch
- Remove the end bell where the wires come out. There will be four long bolts and nuts holding the motor together (below).
- With just the starter end removed, there should be a white plastic terminal board. You can either loosen this board or if you can get to the starter points, (they are on a long copper piece) they open up after the motor gets to a certain speed.
- Take an emery file and sand the contacts to polish up the copper contacts (below).
FINISHED!
Aug 12, 2021
Recent Posts
-
Mastering Your Compressor: How to Set the Perfect Pressure for Any Job
One of the most frequent questions we hear at Master Tool Repair is: "What pressure should my air co …Jun 6, 2025 -
What Is an Aftercooler and Why Does Your Air Compressor Need One?
If your air compressor is producing hot, moisture-heavy air, you could be putting your tools and equ …May 22, 2025 -
What Is a Compression Ring & Why Does Your Air Compressor Need One?
If your air compressor isn’t holding pressure like it used to, a worn-out compression ring mig …May 8, 2025