How-To Install the Newer DT90K Aftercooler
- The kit comes with an adapter, o-ring and 2 bolts.
- The adapter will bolt on to the location of the aftercooler.
- The elbow (with a compression fitting) will screw into the adapter.
- The finned, copper line will connect to the elbow.
- The other end of the line will connect to the unloader valve.
Note: This aftercooler typically mounts to the T39 pump on the 30 gallon gas-powered units.
Aug 2, 2021
Recent Posts
-
Power Loss? How to Identify & Replace Worn Air Compressor Piston & Cylinder Kits
If you’ve noticed your air compressor is taking longer than usual to reach full pressure, or if it s …Feb 25, 2026 -
Just Got a New Air Compressor Pump? Master the Air Compressor Break-In Process!
Congratulations! You’ve just upgraded your setup with a high-quality replacement pump. Whether you’r …Feb 17, 2026 -
Fix Low Pressure and Slow Fill: A Practical Troubleshooting Guide
Is your air compressor taking forever to reach "cut-out" pressure? Low pressure and slow fill times …Feb 10, 2026