How-To Blogs & Videos

INSTRUCTIONS FOR CONVERTING SINGLE STAGE COMPRESSORS TO DUAL STAGEEMGLO DUAL CONTROL OPERATIONSINGLE STAGE DCSTWO STAGE DCT (WITHOUT MAGNETIC STARTER)A. PRESSURE SWITCH MUST BE SET AT APPROX. 8 PSI ABOVE PILOT VALVE CUT-OUT PRESSURE.B. WHEN SWITCHING FROM "CRC" TO "AUTO", TANK PRESSURE WILL DROP TO APPROX. 25 PSI BELOW CUT-OUT PRESSURE BEFORE "AUTO" CONTROL TAKES OVER.A.  PARTS KIT FOR CONVERTING FROM                      CONS …

All you have to do if you have compression style fittings on either end of your supply tube is to:1. Determine the length of transfer tube that you will need. (write down this length needed) 2. Unplug your air compressor from power source to prevent accidental start up while working. 3. Completely drain the air in your tank using your drain cock on the bottom of the tank. 4. Remove the old transfer tube from your air compressor. 5. Remove the outlet compression adaptor from …

This document covers the installation of the CW301300AJ/CW301400AJ pressure switch conversion kit.Use this instruction guide for assembly and operation information.  This guide is designed to supplement the other instructional manuals.  Carefully read all manuals and safety information before operating the compressor. Click here to open the document.

This short video shows how to find a model number on a Campbell Hausfeld air compressor.

Few things are as frustrating as your air tools underperforming due to a lack of power. You've got a perfectly good air compressor, but your impact wrench feels weak, your paint gun sputters, or your sander just doesn't have the oomph it should. The culprit? Pressure loss in your compressed air system. Pressure loss means the air pressure delivered to your tools is significantly lower than what your compressor is producing. This isn't just an annoyance; it wastes energy, reduces tool lifespan, a …