1/2" MPT Air Filter Assembly #0A12AA

Complete filter assembly including filter element. 1/2" threaded inlet. 2-1/4" x 6-1/4". Takes the #14-SOL Filter Element.

Replacement Filter Element for (#1-4) Filter Assby. #0A12AE

Generic replacement filter element, fits all "FS-14" Assemblies. 4.25"OD x 3"ID x 2 3/8" Height. Replace every 3-4 months if air compressor is used frequently. A dirty filter can cause damage to the pump's valves, clog your check valve and reduce the CFM...

1/4-14x 1 Hx HD Tek Screw Zp #07FB5D

Old Part Numbers: MFMIS10008

Rubber Hose, 1/4" #08001A

1/4" OD for throttle/idle control. Sold by the foot (qty. 1 = 1 foot).

Bolt #07FB47

K17 Pump (Less Flywheel) #07FA2A

Up to 11.11 cfm with 3 HP motor. Cast iron cylinders. Reliable workhorse found on most contractor models. Save money by using your old flywheel and aftercooler. Includes air filter. Footprint is 7.08" x 5.19". Does NOT ship with oil.  Note: A model...

Black Nipple #07FB43

Bracket, Accessory #07FB45

Belt Tightening Device 5hp Engines #07FB63

Old Part Numbers: SBT5HP-SQUARE

THROTTLE CONTROL KIT #07F8DB

Old Part Numbers: MF192EGX160K1QXThrottle control mounts above on/off switch and tells motor when to speed up or slow down. Replace if yours is sticking or leaking.Technical DocumentsClick here for installation instructions

3/16 Key Stock #07FB65

5/16 Lock Washer #07FB49

Brass Nut #07FC89

Black Nipple #07FB55

Flywheel #07FC8E

11" diameter with a tapered bore

Black Nipple #07FA91

Old Part Numbers: MFBLNP0250X1500

Oil Drain Tube for GX120-GX200, 10mm #07F8F7

Stop making a mess! This oil drain tube makes changing your oil easy. Simply remove your oil drain plug and install the metric threaded end into your engine block. Changing oil has never been so easy!Technical Documents Click here to an install video...

Brass Elbow #07FB51

Black Cap #07FB59

Nut #07FB4B

CRANKCASE BREATHER K50 3/8_INCHES #07F8A9

Old Part Numbers: 36500300CH Crankcase breather with o-ring.

Cotter Pin #07FDB4

Tubing, 1/4 #07FDA7

Old Part Numbers: MIS11100Sold by the foot. (Example: Order qty 2 for 2 feet)

Wrought Washer #07FB61

Hose Clamp #07FA22

5/8" Hose Clamp. Uses two.

Foot Rubber #07F8E1

Old Part Numbers: RB1575, 624654Keep your unit from sliding all around your vehicle or floor. Order extra for future use. 3/4" Height, 1 1/2" Diameter

Brass Coupler #07FB4D

Old Part Numbers: MFBRCP0375X0375H12

Wheel #07F8E5

Old Part Numbers: WLS30-SEAL, WLS30, WLS30SEALFully pneumatic wheel assby w/sealant. Just slide onto axle.

Lock Nut #08015F

Nut #07FCFA

20 Gallon Tank Assembly #08015D

Tank includes rubber pads, handle grips, decals and tank drain. Does not include wheels.

SAFETY VALVE 14 inch - ASME #07FA1E

Old Part Numbers: SRV0250N165If your valve leaks below the pressure listed on the side of the valve, replace this vital safety feature.

Pilot/unloader Valve #07F9B4

Pilot, Unloader Valve w/ Large Fitting. Replace if compressor insn't cutting on or off at the correct psi.

K17 I STAGE Pump (Includes Flywheel and Air Filter) #07F89A

Up to 11.11 cfm with 3 HP motor. Cast iron cylinders. Reliable workhorse found on most contractor models. Shipped w/ 11.5" steel flywheel, aftercooler and air filter assby. Footprint is 7.08" x 5.19". Does NOT ship with oil. Please note that a model...

Compression Ring #080005

Rubber Hose #07FA20

3/8" Rubber Hose, sold by the foot. (Example: Order qty 2 for 2 feet)

Belt Guard Assby. #07FC8B

Old Part Numbers: BG9145, BG9140BIncludes base, cover and cover screws. Custom made. 3-4 week ship time.

Cc Clamp - 1/2 #07FB6F

Washer #07FBCB

Bolt #07FB6B

Brass Elbow #07FD97

Spin Lock Bolt #07FB0F

Handle, Fc2002 #07FAB3

Old Part Numbers: FC127GH0012, 020121000F, FC127HQ0130

Elbow, Brass #07FC87

Check Valve, Drilled #07FF91

Check Valve (standard units - No auto tank drain).

Belt, 51" Long A49 #0811DD

Old Part Numbers: 4L510

Washer #07FD38

FLEXIBLE DISCHARGE TUBE, 12" LENGTH #07FD08

Old Part Numbers: 145A, mf145a1/2" MPT x 7/8"-14 JIC female flare swivel x 12" long (see Specs tab for more detail). NOTE! If you don't have a 1/2" female NPT check valve inlet, order the CTB1212 Check Valve and the BRST0500X0500FL flare...

Ball Valve Drain Cock, 1/4" #07F9AC

Old Part Numbers: 079077010059, 200675GS, MF132BV1/4 turn, that's it! 1/4" MPT Ball Style Drain Cock. Keep your tank from rusting. Replace this if leaking or will not work.  Extra DetailsThis was a new check valve installed less than a year ago. Due to...

Manifold #07F927

Aluminum Block Manifold (5-way).

Washer #07FCF8

Flat Washer #07FB69