Old Part Numbers: K0058, K-0058, K0650, K-0650 Sears 919.16014, 91604, K-0650Compression ring replacement kit includes the cylinder, piston ring, retaining screw, o-ring, and head o-ring. Restores...

Adjustable air regulator assembly for air compressor units that have a 4-port pressure switch. 1/4" FPT inlet/outlet, 1/8" FPT port for pressure gauge (to maximize performance, we recommend including...

Plastic fan to cool pump and motor. 6" outside diameter.Specifications Length: 5" Width: 5" Height: 1.850"

Old Part Numbers: AB-9053138, AB-9050373, ST070324AV, 90503731/4" MPT x 1.5" steel pipe nipple. Be sure to apply plumber's tape on the threads before installation.

O-ring seal for air compressor valve plate, installs in between the cylinder and valve plate. Used with origina

Old Part Numbers: 5130038-00, 5130024-001/4" OD brass compression nut and sleeve for bleeder (unloader) tube for air compressors.

Order this if ordering valve plate or a new head.

Old Part Numbers: SRV250150Air compressor safety relief valve, 1/4" MPT, 150 PSI, ASME. If your valve leaks below the pressure listed on the side of the valve, replace this vital safety feature...

Screw for the plastic motor/pump shroud.

Brass compression nut and sleeve for 3/8" OD tubes.

Air compressor compression ring, pre-formed. Note: After you install the ring on the piston rod, install the rod in the cylinder by inserting the rod from the top of the cylinder and pull it down...

Isolator for the pump/motor assembly base. NOTE: To replace all of them you will need to order a quantity of 3. Keep your compressor from vibration damage and replace if any are missing.

Hex Nut for the pump head. The discharge tube attaches to this part. Order the required AC-0781 O-ring Seal as well if needed.

Old Part Numbers: AB-ACG18Saddle mount cup for the motor/pump feet. This installs on the mounting feet of the motor/pump assembly and keeps it from vibrating, as well as reducing noise.

1/4" male NPT x 1/8" female NPT brass bushing reducer for air compressors.

Old Part Numbers: SSW-7367Strain relief for air compressor power cord going into the pressure switch housing.

Screw, .250-20 x 1.25" U. This is one of the screws for the pump head; also used to attach the saddle mount cup/foot to the base of the pump.

Old Part Numbers: SSF-3158-1This is the screw that holds down the piston cover, on the top of the piston.

Screw, #10-14 x 2.50". This is the screw for the air intake muffler cover (2 used).