Air compressor check valve. 3/8" Comp x 1/2" MPT with 1/8" FPT side port.  The check valve is a one-way valve that prevents air from back-feeding from the air tank. If your unit has a hard time...

O-ring Seal for the discharge (outlet) tube to the pump head.

Old Part Numbers: GA0125200, PG0125200BKAir Compressor Pressure Gauge, 1/8" MPT, Back-Mount, 200 PSI, 1.5" Face. Replace if misreading or broken.Specifications PSI: 0-200 PSI MPT: 1/8" MPT Dial /...

Old Part Numbers: 5130038-00, 5130024-001/4" OD brass compression nut and sleeve for bleeder (unloader) tube for air compressors.

Old Part Numbers: SRV250150Air compressor safety relief valve, 1/4" MPT, 150 PSI, ASME. If your valve leaks below the pressure listed on the side of the valve, replace this vital safety feature...

Brass compression nut and sleeve for 3/8" OD tubes.

Air compressor regulator repair kit includes the plug with ring, o-ring, spring, piston with seal, disk with o-rings, and seal lube with instructions. Used on many brands from Craftsman to DeVilbiss...

Isolator for the pump/motor assembly base. NOTE: To replace all of them you will need to order a quantity of 3. Keep your compressor from vibration damage and replace if any are missing.

Hex Nut for the pump head. The discharge tube attaches to this part. Order the required AC-0781 O-ring Seal as well if needed.

Old Part Numbers: AB-ACG18Saddle mount cup for the motor/pump feet. This installs on the mounting feet of the motor/pump assembly and keeps it from vibrating, as well as reducing noise.

Old Part Numbers: 69D109668Pressure switch cover for most 69 Series Furnas/Hubbell air compressor pressure switches.Specifications 3-3/8" long x 2-3/16" wide x 1-1/2" tall

Old Part Numbers: D20763, D27254, D206434-Port OEM Air Regulator. The Regulator controls the amount of air to your hose. Replace this if you're not able to adjust the PSI to your hose or if it leaks...

1/4" male NPT x 1/8" female NPT brass bushing reducer for air compressors.

Old Part Numbers: SSW-7367Strain relief for air compressor power cord going into the pressure switch housing.

Screw that fastens the front and back of the belt  guard to each other, and to the compressor base. THD FORMING

Plastic shroud (cover) Screw, #10-9 x .500 Thd. 

Old Part Numbers: 5130940-00, SSF-8080-ZNFlange nut to attach the wheel to the air tank.

Screw to fasten the handle to the compressor base.