Replacement air compressor pump assembly i11 with threaded exhaust port service for Craftsman, DeWalt, and Husky compressors with 1/2" NPT threaded exhaust port, 2 - 5 HP.   Does NOT include flywheel...

Old Part Numbers: E100048, E100104, E100794, E100434, E101178, E100204, E100846Protect your air compressor pump from damage with this air filter assembly intake, 1/2" NPT. Includes the filter base,...

Old Part Numbers: 072-0006Replace this air compressor drain valve if leaking or will not work. Prevent rust from ruining your tank by draining your tank daily. Keep an extra around for a spare. This...

Poly-V Pulley, 6.923" outside diameter (OD) with a 5/8" bore (ID). Includes the key and set screws.  

Old Part Numbers: 500J6, BT004800AVAir compressor poly-grooved "J6" belt, 50" circumference. Replace if cracked, worn, or slipping.

Genuine OEM Flywheel, 12" OD. Includes Mounting Bolt and Washer.Specifications 12" OD Includes Mounting Bolt & Washer Requirements Fits Husky Models: C602H - Type 3 C304H - Type 1  C603H  DeWalt:...

Element only for air compressor air filter assembly. Also offered is the E100Kit, which includes the filter element, oil sight glass, and crankcase breather. Replacing the pump's air filter regularly...

1/2" brass compression and nut and sleeve for rigid tubes. The ferrule/sleeve is built in to the nut.

Old Part Numbers: 5130038-00, 5130024-001/4" OD brass compression nut and sleeve for bleeder (unloader) tube for air compressors.

Old Part Numbers: MDR11Condor MDR11 series air compressor pressure switch. Cut-on PSI 120, cut-off PSI 155. 120V / 230V-240V. Replace the pressure switch if the compressor no longer cuts in or cuts...

1/2" NPT x 3/8" OD Tube. If your pressure switch is leaking at the unloader valve, replace this part.

1/2" Discharge Tube with Compression Nuts & Sleeves. Since it will restrict airflow, replace if the tube is kinked, damaged, or leaking.

Old Part Numbers: GA030000AV, A14993, E110954, GA016700AV, GA031000AV, GA015000AVAir Compressor Pressure Gauge. 2" OD Face, 1/4" NPT bottom-mounted thread, 300 PSI gauge. Buy a second one to ensure...

Includes two O-Rings (2" OD). This is the large O-ring Seal for the inspection port/bushing on the side and bottom (where the drain cock is) of the air tank.

Pressure Relief Tube (no fittings included). This is the 1/4" OD tube that connects from the in-tank check valve to the pump head. 

1/4" NPT ASME Safety Relief Valve, preset to 200 PSI.  If your valve leaks below the pressure listed on the side of the valve, replace this vital safety feature.

2" x 1/4"

2" NPSM X 3/4" NPT (SVC)

Set screws for air compressor motor pulley. Includes 2. Torque to 145 - 180 in/lbs. 

Pipe Nipple, 1/4" NPT-18 x 2.0" length. Make sure to apply Teflon tape to the threads for the proper seal.

Kit of 2

4" x 4" rubber isolator pads.

Old Part Numbers: E105537, E105991Interconnect cord from the air compressor motor to the pressure switch.

Old Part Numbers: E108110

Old Part Numbers: E108246