Old Part Numbers: Z-AC-0032, AC-0032Valve plate comes with preinstalled valves and o-rings. Poor performance or air leaks out of the intake filter while the unit is running? This is probably the...

Old Part Numbers: K0058, K-0058, K0650, K-0650 Sears 919.16014, 91604, K-0650Compression ring replacement kit includes the cylinder, piston ring, retaining screw, o-ring, and head o-ring. Restores...

Old Part Numbers: KK-4835, CAC-118, 889124, 889125, 891125, AC-0788, CAC-1118, D25009, D25837, CAC1118, CAC118, CAC-249, CAC-249-1, A02743, K-0651, KK-5081, 889124 889125 891125 AC-0788 CAC-1118...

Plastic fan to cool pump and motor. 6" outside diameter.Specifications Length: 5" Width: 5" Height: 1.850"

Air compressor check valve. 3/8" Comp x 1/2" MPT with 1/8" FPT side port.  The check valve is a one-way valve that prevents air from back-feeding from the air tank. If your unit has a hard time...

O-ring Seal for the discharge (outlet) tube to the pump head.

Old Part Numbers: SV25200, SRV250200, 1229O-200, 9710533300, 136-0007RPAir compressor safety relief valve, 1/4" MPT, 200 PSI. If your valve leaks below the pressure listed on the side of the valve,...

Head Gasket

O-ring seal for air compressor valve plate, installs in between the cylinder and valve plate. Used with origina

Old Part Numbers: 5130038-00, 5130024-001/4" OD brass compression nut and sleeve for bleeder (unloader) tube for air compressors.

Order this if ordering valve plate or a new head.

Brass compression nut and sleeve for 3/8" OD tubes.

Rubber o-ring for air compressors, .362ID x .103W. This is the o-ring seal for the pump end of the outlet tube.

Screw (fastener) for the motor/pump shroud.

Isolator for pump base. Keep your compressor from damage by replacing these isolators if missing or damaged.

Hex Nut for the pump head. The discharge tube attaches to this part. Order the required AC-0781 O-ring Seal as well if needed.

Old Part Numbers: AB-ACG18Saddle mount cup for the motor/pump feet. This installs on the mounting feet of the motor/pump assembly and keeps it from vibrating, as well as reducing noise.

Old Part Numbers: AC-0558Grip for the air compressor handle, .875" diameter.

1/4" male NPT x 1/8" female NPT brass bushing reducer for air compressors.

Old Part Numbers: SSW-7367Strain relief for air compressor power cord going into the pressure switch housing.

Old Part Numbers: 5130940-00, SSF-8080-ZNFlange nut to attach the wheel to the air tank.

Screw to fasten the handle to the compressor base.

Screw, .250-20 x 1.25" U. This is one of the screws for the pump head; also used to attach the saddle mount cup/foot to the base of the pump.

Screw, #10-14 x 2.50". This is the screw for the air intake muffler cover (2 used).

If your valve is leaking on the side of the switch, do not order this part. Order check valve instead. 175 / 145 PSI , 4 Port , 24amp 120V / 240 Two Pole Switch