This is the main Outlet (Discharge) Tube only. Replace if kinked or if leaking. O-Rings & Nuts not included, purchase separately.

Set of 2. These are the seals for either end of the discharge tube.SpecificationsMeasures .301" ID x .070" wide

Old Part Numbers: 072-0006Replace this air compressor drain valve if leaking or will not work. Prevent rust from ruining your tank by draining your tank daily. Keep an extra around for a spare. This...

Husky Air Compressor Regulator / Manifold Kit includes the regulator and manifold (no pressure gauge). The regulator controls the amount of air to your hose. If air leaks from the regulator, or when...

Set of 2; includes two nuts for each end of the air compressor transfer tube.

This is the main Outlet (Discharge) Tube only for the Husky C201H Type 2 and C202H models. Replace if kinked or if leaking. Includes everything you need: Discharge Tube Brass Nuts O-ring Seals

Old Part Numbers: N043321On/Off rocker switch for Craftsman/Husky air compressor units.

Cylinder Gasket, U4 Service for air compressors.

Old Part Numbers: E111693

OEM pressure switch replacement, 160 PSI cut-in pressure, 200 PSI cut-out pressure. Replace if the unit doesn't cut in or cut out at the designated PSI.

Husky replacement air compressor check valve, 1/2" NPT x 9/16" FPT. If the small unloader (bleeder) valve on or under your switch leaks constantly AFTER the unit shuts off, replace this part. This is...

Old Part Numbers: E108522Includes bottom shroud (only) for Husky C201H and C202H air compressor models. Replace if damaged or missing, and keep your fingers intact and debris out of the motor and...

Husky Valve Plate U4 Service for air compressors. Includes the valve plate with valves installed. If air leaks out of the intake filter or if the compressor just isn't performing like it should,...

Old Part Numbers: E108872Set of four (4) screws for the air compressor pump head.

Cooling Fan for the motor. Keep your motor running cools by replacing if any fins are missing or damaged.

This is the Head O-ring on top of the valve plate, in between the valve plate and the head.

OEM Connecting Rod Assembly, includes the conrod with bearing, piston (compression) ring, and cylinder cup. Replacing the cylinder sleeve and piston ring usually restores compression in oil-free...

Complete oil-free, direct-drive air compressor motor/pump assembly.

Clamps for the air compressor regulator / manifold hose. .25" ID, Set of 2

#10-14 Plastite screw for the plastic shrouds. Includes 1 screw.

Hose that connects to the air compressor pressure switch.

Isolator kit for your air compressor tank to keep it from dancing; reduces vibration. Includes three (3) isolator pads.

Husky 14-Gauge Air Compressor Power Cord, 120V, SJ-rated. Includes the power cord and wire terminals. Replace if frayed or cut, or if it no longer conducts current.

Set of two (2) shoulder bolts for the air compressor wheels.

Kit of 2

Set of two (2) air compressor pressure gauges.Specifications 1/8" MPT: 1/8" PSI: 300 PSI Dial / Face: 1.5" Back-Mount

Includes one (1) screw for the air compressor shroud.

Main handle for the air compressor tank. Silver. Hardware to install the handle not included.

Old Part Numbers: E108246