Old Part Numbers: A19715, CAC-4337-1, D288261/2" male NPT x 1/2" compression check valve, with 1/4" compression adapter. For model D55167 type 1 and others. If the small unloader (bleeder) valve on...

Old Part Numbers: GA0125200, PG0125200BKAir Compressor Pressure Gauge, 1/8" MPT, Back-Mount, 200 PSI, 1.5" Face. Replace if misreading or broken.Specifications PSI: 0-200 PSI MPT: 1/8" MPT Dial /...

Old Part Numbers: CAC-291-1, Z-CAC-291-1Top head gasket.

Old Part Numbers: 5130038-00, 5130024-001/4" OD brass compression nut and sleeve for bleeder (unloader) tube for air compressors.

Old Part Numbers: 9-16279 4-1/2" X 1-1/2" X 9/16"

Must order quantity of 4 for complete set. 1/4"-20 x 1-1/4 length.

Old Part Numbers: SRV250150Air compressor safety relief valve, 1/4" MPT, 150 PSI, ASME. If your valve leaks below the pressure listed on the side of the valve, replace this vital safety feature...

1/2" compression nut and sleeve, brass.

Old Part Numbers: 265-16Crankcase/Base Gasket for the Craftsman/DeVilbiss/Porter Cable in-line, twin-cylinder, single-stage aluminum air compressor pumps. This is the Gasket in between the bottom...

Old Part Numbers: 69D109668Pressure switch cover for most 69 Series Furnas/Hubbell air compressor pressure switches.Specifications 3-3/8" long x 2-3/16" wide x 1-1/2" tall

Poly-groove J6 Ribbed Belt for air compressors, 38" outer circumference. Belt Width (in) : .563 in.Belt Width (mm) : 14 mmEffective Circumference (in) : 38 in.Effective Length (mm) : 965 mm

1/4" male NPT x 1/8" female NPT brass bushing reducer for air compressors.

Plastic plug for the piston pin (two used per piston).

Vent filter for the pump crankcase. This fits into the top of the cylinder.

Replace if pitted or grooved along w/ 2 new rods. -Rods not inlcuded-

Old Part Numbers: Z-CAC-1265-2PL THIC

Old Part Numbers: SSW-7367Strain relief for air compressor power cord going into the pressure switch housing.

Old Part Numbers: D20675, AC80-BQuick-connect coupler, 1/4" male NPT x 1/4" body.

Old Part Numbers: D24888, D30198, 5135135-00Pipe Nipple, 1/4" male NPT x 1/4" long. Don't forget to apply Teflon Tape to the threads to seal it.

Old Part Numbers: 5130940-00, SSF-8080-ZNFlange nut to attach the wheel to the air tank.

Old Part Numbers: SST-108, A14785Rubber air compressor isolators with screws, three (3) included.

Pin for the piston. One used per piston.

Washer for the flywheel bolt.

Old Part Numbers: CAC-4205, SUDL-402-2Assembly Cord Motor SJT for air compressors.

.313-18 WING

Old Part Numbers: SSN-56-ZN1 X 11/32 X 1