Old Part Numbers: 072-0006Replace this air compressor drain valve if leaking or will not work. Prevent rust from ruining your tank by draining your tank daily. Keep an extra around for a spare. This...

Old Part Numbers: TF060402AVCampbell Hausfeld Tube Fitting with Compression Nut (175 PSI) for air compressors. Head Fitting including screws, compression nut, compression sleeve and o-rings.

Old Part Numbers: SV25200, SRV250200, 1229O-200, 9710533300, 136-0007RPAir compressor safety relief valve, 1/4" MPT, 200 PSI. If your valve leaks below the pressure listed on the side of the valve,...

Old Part Numbers: TF059700AJ, TF061700AJBroken valve causing slow pressurization or no compression at all? Replace this head and valve plate assembly to restore compression. Includes everything...

Old Part Numbers: TF002000BHIntercooler Tube that connects from one cylinder to the other. Replace if kinked or punctured. Note: Does not include fittings.

Tube Fitting Assembly includes fitting, compression nut & ferrule, screws, 1/8" MPT plug and o-ring. Note: Order this item for model 5Z404E and others.

Old Part Numbers: MFGA0250200GC, PG0250200BTAir Compressor Pressure Gauge, 1/4" MPT, 200 PSI, Bottom-Mount. Replace after 5 years as they weaken and give improper readings.Specifications PSI: 0-200...

Campbell Hausfeld Air Compressor Pump Gasket Kit includes all main gaskets and o-rings seals. Important: For v-twin pumps, you'll need to order 2 kits to rebuild the complete pump. Note: Inlet gasket...

Note: order this item for model 5Z404E.

Stagger rings and hone cylinders when installing. Includes piston rings for two air compressor pistons. NOTE: For v-twin pumps, you need qty. 2 to rebuild complete pump.Technical DocumentsClick here...

Old Part Numbers: 60-123/4" brass compression sleeve (ferrule) for air compressors. Order compression nut separately, if needed.

This is the Gasket in between the pump's crankcase and the cylinder. Also included in a complete Gasket Kit.

Old Part Numbers: CI050000PC, CI070000PD, TF2111, TF2511, CI050000PD, TF2101, TF2501OEM twin-cylinder, two-stage replacement air compressor pump with flywheel, intercoolers, and air filter assembly...

Old Part Numbers: 61-12, 997-57781Compression nut, 3/4" OD, brass. Don't forget the compression sleeve/ferrule! 

Air compressor check valve, 3/4" Compression x 3/4" MPT with 1/8" FPT side port.  If the small unloader (bleeder) valve on or under your switch leaks constantly AFTER the unit shuts off, replace this...

Air compressor pump air filter kit includes the canister assembly, filter element, bolts, washers, and wingnut. Note: Order this kit for CI0500 models and others. Replacing the pump's air filter...

Old Part Numbers: SRV187075, SRV187-1/8Air compressor safety valve, 75 PSI, 1/8" male NPT.  

Old Part Numbers: ST072231AJ, ST072231AV3/4'' male NPT Elbow. This is typically installed in between the tank Check Valve and the Discharge Tube.

Old Part Numbers: ST070387AV-MAT1/4"-18 NPT x 2.5" long pipe nipple for air compressors. Don't forget to apply plumbers' (teflon) tape to the threads for a tight seal.Extra DetailsIf you have a...

Needle bearing for connecting rod (one used per rod).

Old Part Numbers: 68-4-21/8" male NPT x 1/4" compression adapter for air compressor unloader/bleeder line. A very common adapter to attach the 1/4" OD unloader/bleeder line from the unloader valve on...

Old Part Numbers: TF050100AV

Smaller, high-pressure (HP) piston with rings. Stagger rings and hone cylinder prior to installing.

Larger, Low-Pressure (LP) Piston with rings. Stagger the rings and hone cylinder prior to installing.

New crankshaft assembly with ball bearings.

Old Part Numbers: ST016500AV

Bare Cylinder for two-stage pump. Order any necessary gaskets separately.

145/175 PSI, Single-Port manifold w/ Unloader Valve.

Note: order this item for models VT615208, VT617205, VT617206 & EX800300 only.