Old Part Numbers: 019-0246, 019-0023Replacement air filter element, Rolair 431. Fits the K12 through K30 air compressor pumps.

Old Part Numbers: TF060402AVCampbell Hausfeld Tube Fitting with Compression Nut (175 PSI) for air compressors. Head Fitting including screws, compression nut, compression sleeve and o-rings.

Old Part Numbers: SV25200, SRV250200, 1229O-200, 9710533300, 136-0007RPAir compressor safety relief valve, 1/4" MPT, 200 PSI. If your valve leaks below the pressure listed on the side of the valve,...

Old Part Numbers: TF059700AJ, TF061700AJBroken valve causing slow pressurization or no compression at all? Replace this head and valve plate assembly to restore compression. Includes everything...

Old Part Numbers: CTB3434Air Compressor Check Valve, 3/4" Female NPT x 3/4" Male NPT air compressor with 1/8" Female NPT side port. If the small unloader (bleeder) valve on or under your switch leaks...

O-Ring Seal for the triangular intercooler and aftercooler fittings on the pump head.

Polyester air filter element for air compressors. Found on many larger units and older units. Fits the S1097 & 1312100375 filter assemblies. .5 micron up to 6,600 SCFM

Campbell Hausfeld Air Compressor Pump Gasket Kit includes all main gaskets and o-rings seals. Important: For v-twin pumps, you'll need to order 2 kits to rebuild the complete pump. Note: Inlet gasket...

Tube Fitting w/ 1/8" FPT port.

Stagger rings and hone cylinders when installing. Includes piston rings for two air compressor pistons. NOTE: For v-twin pumps, you need qty. 2 to rebuild complete pump.Technical DocumentsClick here...

This is the Gasket in between the pump's crankcase and the cylinder. Also included in a complete Gasket Kit.

Old Part Numbers: 3168Air compressor pressure switch/manifold pipe plug, 1/4"-18 male NPT. A very common hex plug used on countless air compressors, this 1/4" NPT countersunk hex plug installs into...

3/8" male NPT Drain Cock for the tank. Prevent rust from ruining your tank by draining your tank daily. Keep an extra around for a spare!

Old Part Numbers: TF061300AVCylinder-to-Valve Plate Gasket. Remember to tighten the head bolts down to the appropriate torque spec when reinstalling the head.

Old Part Numbers: 61-12, 997-57781Compression nut, 3/4" OD, brass. Don't forget the compression sleeve/ferrule! 

Pressure switch, 135/175 PSI. Single-port w/ 1/4" compression unloader valve. Replace the pressure switch if the compressor no longer cuts in or cuts out at the designated pressure (PSI), if the unit...

Old Part Numbers: TF060300AVHead Gasket for the TF/TX series pumps. Replace if leaking or if the intercooler safety relief valve blows off.

Air compressor pump air filter kit includes the canister assembly, filter element, bolts, washers, and wingnut. Note: Order this kit for CI0500 models and others. Replacing the pump's air filter...

Old Part Numbers: ST072231AJ, ST072231AV3/4'' male NPT Elbow. This is typically installed in between the tank Check Valve and the Discharge Tube.

(Less Dipper).

Old Part Numbers: ST070387AV-MAT1/4"-18 NPT x 2.5" long pipe nipple for air compressors. Don't forget to apply plumbers' (teflon) tape to the threads for a tight seal.Extra DetailsIf you have a...

Needle bearing for connecting rod (one used per rod).

Old Part Numbers: TF050100AV

Old Part Numbers: BG217000AJSquare Wire Air Compressor Belt Guard (Front).  If you need the back Belt Guard as well, order BG217100AV.

Old Part Numbers: CI15K000PC, CI15K000PP, TX021100AVTwo-stage, v-twin air compressor pump replacement. Complete assembly with flywheel and air filters. Rated at 15 HP. Note: Order this item for model...

Old Part Numbers: BG217100AJNew OEM belt guard replacement (back). This is the base of the belt guard that fastens to the compressor. Protect your fingers from moving parts. OSHA required.

Connecting rod assy including dipper.

Old Part Numbers: TX031900AVCopper discharge tube from the pump head to the tank.

Old Part Numbers: STD-3353/8"-16 flange nut. Also used on models VT627000, VT629100, VT618202 and VT622001.

Left Cylinder facing the flywheel.

Old Part Numbers: TX000900APFor the right cylinder, facing flywheel.

Smaller, high-pressure (HP) piston with rings. Stagger rings and hone cylinder prior to installing.

Old Part Numbers: TX2101, 5Z405B, 5Z405, CI100000PD, CI100000, TX2001Complete air compressor pump assembly including flywheel and air filter assemblies. 10 HP. Just add oil, install the belts and...

Bare Head for the pump, no Gaskets included. If you need the Gaskets, order the Complete Gasket Kit.

3/4" compression tee fitting.

(Right Cyl. facing flywheel).

Larger, Low-Pressure (LP) Piston with rings. Stagger the rings and hone cylinder prior to installing.

Campbell Hausfeld load genie check valve.  This valve is a combo check valve and pilot unloader valve.  This valve is used on units that are continously running air compressors (many Campbell...

For CI15K models. Kit includes filter element, element housing assembly, wingnut, o-ring, screw, and washer. Replacing the pump's air filter regularly is important to maintain the performance and...

Campbell Hausfeld Crankshaft Assembly with Bearing Cones for air compressors.

Old Part Numbers: TX000800APFor left cylinder.

Old Part Numbers: ST016500AV

Old Part Numbers: ST067500AV, ST072024AV

Replace if bent or leaking. Be sure to install new fittings as well.

Old Part Numbers: ST000600AV(1/4)

Old Part Numbers: TF202700AV

0.024" (Not Shown).

Bare Cylinder for two-stage pump. Order any necessary gaskets separately.

Old Part Numbers: ST094700AV, TW003800AGBreather assembly includes Tube, Mesh, Ball, Cap & Screw.

Old Part Numbers: MC024200IP, MC022395AV, MC030800AVElectric motor for air compressors, WEG. 10 HP, 3 Phase, 208-230/460 volt.

Old Part Numbers: GA016703AVReplacement Pressure Gauge, 300 psi, 2" Face, Back-Mount (1/4" male NPT).

Only available in the TX036100AV Breather Assy.

NOTE: Intercooler Safety Valve is only 75 PSI Note: For CI15K models.

Old Part Numbers: ST122007AVModels CE800100, CI103120HPMS only. 10 HP Magnetic Starter, 208-230 Voltage, 3 Phase. Important: Electrical components, such as magnetic starters, motors, capacitors (etc...