Old Part Numbers: 61-8

Crankcase breather assembly for air compressor models with threaded type crankcase for the breather. This assembly tightens into the crankcase; typically has an oil-level sight gauge.

Element only for air filter assembly. Order 2 or 3 for spares. Replace this every 3-4 months if the compressor is used frequently. A clean filter allows your pump to operate at its max...

Old Part Numbers: TQ011300AJ, TQ900400AJ, VT470800AJQuad valve plate assembly for air compressors includes the valve plate with valves installed, upper and lower gaskets ONLY. This replaces part...

Old Part Numbers: 019-0239, 201793GS, D23190This Air Filter Assembly, V-Twin Single Stage is the same as the VH901700AV Filter, but has 1/2" MPT PLASTIC threads. One complete assembly. Includes...

Old Part Numbers: AB-9053138, AB-9050373, ST070324AV, 90503731/4" MPT x 1.5" steel pipe nipple. Be sure to apply plumber's tape on the threads before installation.

Air compressor pressure switch replacement, 105/135 PSI, 4-port, 90° quick-connect unloader valve. Replace the pressure switch if the compressor no longer cuts in or cuts out at the designated...

Old Part Numbers: 60-8, STD-329Air compressor brass compression sleeve (ferrule) for a 1/2" OD tube.

Old Part Numbers: SRV250175, 1229O-175Air compressor safety relief valve, 1/4" MPT, 175 PSI, ASME. If your valve leaks below the pressure listed on the side of the valve, replace this vital safety...

Old Part Numbers: BT013100AV4L580 v-belt for air compressors, 58" circumference. Replace if frayed or slipping.Specifications A-type belt, 1/2" wide Outside Dimension: 58" "A" Belt Conversion: A56

Order this Oil Sight Glass if you have the threaded oil breather! Includes the O-ring Seal.

Old Part Numbers: 3168Air compressor pressure switch/manifold pipe plug, 1/4"-18 male NPT. A very common hex plug used on countless air compressors, this 1/4" NPT countersunk hex plug installs into...

3/8" male NPT Drain Cock for the tank. Prevent rust from ruining your tank by draining your tank daily. Keep an extra around for a spare!

Old Part Numbers: GA031900AVAir compressor pressure gauge. Replace if cracked or reading inaccurately. Specifications 1/4" MPT 2" Face Right-Mount 300 PSI

Old Part Numbers: TQ901600AP

This handy maintenance kit includes a VH series air filter assembly and one (1) quart of high-quality synthetic blend lubricant to keep your air compressor running like a champ! Metal air filter with...

Old Part Numbers: TQ300000AVComplete, new TQ3010 replacement pump assembly, includes flywheel and air filter assemblies. Just bolt it on, add oil, and install your belt and discharge tube. Need oil? 

Two Sets.

This handy maintenance kit includes a VH series air filter assembly and one (1) quart of high-quality full synthetic lubricant to keep your air compressor running like a champ! Metal air filter with...

This handy maintenance kit includes a VH series air filter element and one (1) quart of high-quality full synthetic lubricant to keep your air compressor running like a champ! For VT, TQ, and VH air...

Gasket Kit for TQ-series v-twin air compressor pump. Includes head o-rings, crankcase gaskets, cylinder gaskets, and bearing cover o-ring. If the compressor pump doesn't seem to pressurize as quickly...

Air Compressor Pump Quad Head Fastener Kit includes the bare head and head bolts. Order gaskets separately. Remember to tighten the bolts down to the proper torque specs as noted by the manufacturer.

Old Part Numbers: ST012200AVWe have a limited supply of these screws available at our warehouse. The manufacturer is no longer making these screws, so get them while you can. Once sold out, they will...

This handy maintenance kit includes a VH series air filter element and one (1) quart of high-quality synthetic blend lubricant to keep your air compressor running like a champ! For VT, TQ, and VH air...

Old Part Numbers: STD-3353/8"-16 flange nut. Also used on models VT627000, VT629100, VT618202 and VT622001.

Quad Exhaust Tee Fitting for air compressors.

7/8" Shaft and 3.45" Outer Diameter 3.45" Diameter X 7/8" bore, shaft hole. 1/2" (A Sections ) V-Belt

Old Part Numbers: ST016500AV

Air Compressor Conrod / Piston Kit includes the connecting rod assembly, ring set, piston, piston pin, and retaining rings. Important: For TQ300000AV only, not for TQ300000AJ. 

Old Part Numbers: ST000600AV(1/4)

Note: pistons not included.