Old Part Numbers: 058-00073/8" OD compression nut and sleeve (ferrule) for the air compressor transfer tube.

Old Part Numbers: NTB14Use this nylon tube if your air compressor pressure switch has a plastic unloader valve with a quick-connect fitting. Note: sold by the foot (quantity of 1 = 1 foot or 12...

Old Part Numbers: GA0125200, PG0125200BKAir Compressor Pressure Gauge, 1/8" MPT, Back-Mount, 200 PSI, 1.5" Face. Replace if misreading or broken.Specifications PSI: 0-200 PSI MPT: 1/8" MPT Dial /...

Old Part Numbers: SRV250175, 1229O-175Air compressor safety relief valve, 1/4" MPT, 175 PSI, ASME. If your valve leaks below the pressure listed on the side of the valve, replace this vital safety...

Air compressor o-ring gasket that installs in between the cylinder cup and the valve plate. NOTE: This gasket does not go on the piston.

Rubber grommet for air compressor pump/motor assembly. Keeps your motor stable and reduces vibration.

Head O-ring Gasket for the pump. This is the gasket directly under the head and on top of the valve plate.

The Air Compressor Regulator Repair Kit includes only the internal parts for the regulator. If air leaks from the regulator, or when you turn the knob it doesn't adjust the PSI up or down, replace...

Old Part Numbers: 5140121-073/8" compression inlet x 1/2" male NPT outlet check valve with 1/8" hole and plug. If the small unloader (bleeder) valve on or under your pressure switch leaks constantly...

1-1/2" NPSM x 1/4" NPT Bushing Reducer. NOTE: Also order the 513-0002 o-ring seal to complete the repair.

Old Part Numbers: S145-0543, 145-0456Stainless-steel braided tube that runs from pump to tank. Replace if leaking.  Specifications5.5" long with 3/8" compression fittings on each end

Hubcap for wheel, 1/2". Two required.

Drive Belt, .650" wide (5/8"), 6" Diameter.  Is your motor turning yet you have no pressure? Typically this is caused by a torn belt. To make installation easier, "walk" the belt onto the pulleys...

Pin for Regulator Knob.

1/4" body x 1/4" male NPT Industrial Steel Coupler for air compressors.

Spring for air regulator. This is the spring that installs directly into the plastic regulator knob, on top of the diaphragm.

Rubber isolator foot. Reduces vibration and noise.

Old Part Numbers: 112-0031Replacement handle for part # 112-0031.

For air filter.